new warthog adaptor

[ebenitez]

Hello everybody

 

I have been using a warthog adaptor for my Gladiator pro MK I during the last year without any problems until after I swapped the grips with the KG12. When i connected the warthog back (well actually it's a cougar grip) I could see the pins were twisted and didn't make good contact with the base, so I ordered another one from VKB Europe.

When it arrived home I saw it was a bit different than the old one, mainly, it lacked the VKB PCB for electrical compatibility, rather it had only one wire with 5 pins which I guessed would connect directly to the Cougar PCB, I did so, but when I put it back on the gladiator base and loaded the warthog profile, it didn't worked at all. Should I have changed the firmware too? I thought I had the latest firmware installed but in the VKB page I see there is another firmware from July 7th called Gl_MCG_MCG-Pro_v1_94_B.zip.

 

My firmware version is v 1.939

 

Should I update the firmware to the last 1.94 one?

 

Needless to say I have asked this same question to Eduard from VKB Europe but I haven't got any answer yet.

 

Thank you very much