Jump to content

Recommended Posts

Posted

So I installed a slew upgrade for my Warthog throttle. Ran the calibration tool, got everything working fine. Decide to run the stick calibration because for some reason my stick likes to favor the right just enough to throw things a little off balance. (It's not a huge deal, I just throw on my usual deadzone and it's fine) Get to the part where it asks me to unplug. I do so... and then it just loops back to the beginning and is a never ending loop. :huh:

 

 

 

Am I doing something wrong?

  • 2 weeks later...
  • 5 weeks later...
Posted

Hello,

I had the same issues, make sure it is unplugged before you run the stick configuration.

Move the stick very slowly through the travel.

Once you unplug the USB it should show a diagnostic page. It took me a few goes to get this

Many Thanks

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...