DIY Electronics

[mega_mozg_13]

DIY Electronics

 

support up to 8 axes, 128 buttons (including buttons, encoders, toggle switches), RGB indication.

firmware and configuration via a native USB cable; no external devices and drivers are required.

all parameters are configured through the configurator program.

additional software for checking the joystick, communication of several devices, communication of indication with games.

 

USB controller($ 20)

- connection up to 6 digital contactless axes or analog hall / potentiometer sensors (A1-A6);

- connection up to 4 expansion cards, SPI interface compatible with virpil / thrustmaster grips (B1-B4);

- direct connection of 8 buttons with common ground or up to 16 buttons button matrix (BTN1 / BTN2);

- connection indication RGB WS2812;

- sizes 60mm / 32mm, landing M3 46mm / 22mm;

- kit controller board, USB cable.

Digital contactless sensor ($ 10)

-contactless technology works in tandem with a magnet;

-the ability to digitize up to 360 degrees of the course mechanics;

- digital four-wire communication interface, up to 150 cm without loss of speed and signal quality;

- dimensions 42mm / 14mm, landing 35mm M3 between the holes;

- kit sensor board, magnet tablet with a diameter of 5mm and a thickness of 2mm, cable connecting to the controller 20cm;

Expansion Board ($ 10)

- connection via high-speed five-wire SPI interface, up to 150 cm without loss of speed and signal quality;

-the ability to connect up to 20 points of contact buttons / toggle switches / encoders;

-the ability to connect up to 2 analog axes;

- display output in RGB;

- dimensions 50mm / 27mm, landing 42 mm / 19mm M3;

- in a kit expansion board / RGB a payment and a cable of connection to the controller of 40 cm.