Johny2bikes Posted August 26, 2019 Posted August 26, 2019 Hello.. The manual states there should be 12 positions on the master test switch (including off), but when I click through the positions in the cockpit it only has 11 positions (including off). Could this also be the reason we dont get the VMCU checks during start up procedures, as it's around the Emerg Gen position the switch goes out of sync with the labels? I could not find this bug so far in the forum. Apologies if it's already been discussed. Thanks... Johny.
Airhunter Posted August 26, 2019 Posted August 26, 2019 A lot (if not most) of the tests are not modelled as of now. I just ignore that switch completely.
Johny2bikes Posted August 26, 2019 Author Posted August 26, 2019 Ok thanks... that's fair enough. It just threw me when running through the start up training and it asks you to select Emerg Gen and check the VMCU lights (which never worked & is covered in another thread). I just ended up counting the clicks to make sure it was in the right position when I noticed it. No biggie but caused me a bit of confusion so thought I would mention it.
Recommended Posts