Bloody_gums Posted August 27, 2019 Posted August 27, 2019 Hi all sorry to ask but Ive looked everywhere and cant find a detailed step by step answer on how to set the auto lase on so the lgbs get a lser target right before impact? I see the key under lantirn controls but its like declutter/auto/manual/then something else but onxe i hit declutter the auto manual buttons dont do anything? What am I missing? Thanks
electricaltill Posted August 28, 2019 Posted August 28, 2019 I know this isn't the answer for your question, but it would just manually lase all the way down. I found LGBs unreliable when I used auto lasing as it only illuminates the target from (iirc) 10 seconds before impact. HB have also said that in most LANTIRN recordings they had access to the RIO manually lased as well.
Bloody_gums Posted August 28, 2019 Author Posted August 28, 2019 Thats fine and all but highly impracticable in a lot of situations to sit there flying straight and lev head in the pit for 5 to 10 seconds over s target
electricaltill Posted August 28, 2019 Posted August 28, 2019 I guess the answer to your question is "a RIO," then. Once Jester can operate the LANTIRN it hopefully won't be a problem. I'm at work without access to DCS at the moment but I think you have to get into the mode where you enter the laser code (check the manual for that) to be able to turn on auto lasing.
Bruce_D Posted August 28, 2019 Posted August 28, 2019 Hi all sorry to ask but Ive looked everywhere and cant find a detailed step by step answer on how to set the auto lase on so the lgbs get a lser target right before impact? I see the key under lantirn controls but its like declutter/auto/manual/then something else but onxe i hit declutter the auto manual buttons dont do anything? What am I missing? Thanks Hi, This is what you have to do to use auto lase. 1- Go to RIO controls and bind the “LANTIRN Slider Laser/Focus” button (I used the 'S' key). 2- Go to RIO controls and bind the “LANTIRN S4 HAT Press (Declutter/Lase Auto-Man/MGC)” button (I used a button on my joystick) 3- After binding the controls, on the RIO seat, after preparing for attack using the LANTIRN you will press the “LANTIRN Slider Laser/Focus” button and the laser code will start to flash. 4- Press the “LANTIRN S4 HAT Press (Declutter/Lase Auto-Man/MGC)” button. The ‘M’ caps will change to ‘A’. After that press the “LANTIRN Slider Laser/Focus” button again so the laser code will stop flashing. Done! Now you can use auto lase. I always use auto lase with no problems, for me is the easier way to use LGBs. Hope I could help.
Bloody_gums Posted August 28, 2019 Author Posted August 28, 2019 Thanks. No the answer isnt human rio The manual etc is written a little oddly This is how You select the key you have bound to adjust the laser vode. When the numbers begin blinking then hit the button you have hound thstvhas qed then auto lase then declutter (ornwhatever its part of a 4 way hat) it should switch to A instead of M in front of the laser codethen tou just need to keep the target in sight and lined up until impact
Recommended Posts