Slick Fork Posted October 13, 2019 Share Posted October 13, 2019 Hi, I've got an oldish set of Saitek rudder pedals. For a while they worked just fine but I booted up the other day and the toe brake axis (both left and right) are not recognized at all. They show up in Windows Joytest program - when I click on the pedals in the test page it shows them at half axis and then they go empty and neither registers a press. The Z axis works just fine. I've done some reading and it sounds like if it was just one axis it could conceivably be a wire pulled out but what're the odds that two wires pulled out at the exact same time? Or does this sound more likely to be a sensor or board issue? I have zero electrical skill or knowledge... Link to comment Share on other sites More sharing options...
Recommended Posts