Tiger-II Posted December 26, 2019 Posted December 26, 2019 Hi, First of all - awesome module! It is an incredible initial release! I've been learning the ways of the systems, and I know it is possible to slew the RADAR to the current waypoint (though I haven't actually tried it yet), and I wondered if it was possible to slave the targeting pod to the current waypoint? I created a mark point, made it the active nav point, but I couldn't find a way to get the targeting pod to then slew to those coordinates. Is it possible? Motorola 68000 | 1 Mb | Debug port "When performing a forced landing, fly the aircraft as far into the crash as possible." - Bob Hoover. The JF-17 is not better than the F-16; it's different. It's how you fly that counts. "An average aircraft with a skilled pilot, will out-perform the superior aircraft with an average pilot."
[VFA-106] Glacier Posted December 26, 2019 Posted December 26, 2019 MFCD U3 toggles between SP (steerpoint) mode and SLAV (slave to SPI) mode. As long as you have the waypoint specified in the UFCP, then the MWD7 should slew to it in SLAV mode.
Tiger-II Posted December 26, 2019 Author Posted December 26, 2019 Glacier;4152255']MFCD U3 toggles between SP (steerpoint) mode and SLAV (slave to SPI) mode. As long as you have the waypoint specified in the UFCP' date=' then the MWD7 should slew to it in SLAV mode.[/quote'] Hmm. I'll try this again. It didn't seem to work. Thanks! Motorola 68000 | 1 Mb | Debug port "When performing a forced landing, fly the aircraft as far into the crash as possible." - Bob Hoover. The JF-17 is not better than the F-16; it's different. It's how you fly that counts. "An average aircraft with a skilled pilot, will out-perform the superior aircraft with an average pilot."
foxwxl Posted December 26, 2019 Posted December 26, 2019 Select WPT first and Depress SP on the AG MAP page, when showing "SLAV" the sensor is slaved to SPI. Deka Ironwork Tester Team
Recommended Posts