e33et Posted December 27, 2019 Posted December 27, 2019 When i start from a new mission that i've created and choose from either takeoff parking hot or ground hot, with aircraft started up, and then i move my hotas warthog throttle to auto position (yellow leveler) it just shut down the engine because they spinning with full speed from beginning, but not when i press page down, i thought it might could be a bug with the control, i already done a fresh install for other reason. it works on other aircraft when starting from parking hot.
Holton181 Posted December 28, 2019 Posted December 28, 2019 Do you have "synk with hardware controls" or whatever it's called enabled in the DCS setup? Helicopters and Viggen DCS 1.5.7 and OpenBeta Win7 Pro 64bit i7-3820 3.60GHz P9X79 Pro 32GB GTX 670 2GB VG278H + a Dell PFT Lynx TrackIR 5
e33et Posted December 29, 2019 Author Posted December 29, 2019 Do you have "synk with hardware controls" or whatever it's called enabled in the DCS setup? Should i have it disabled when i assign them to yellow leveler? Regards e33et
Holton181 Posted December 29, 2019 Posted December 29, 2019 Should i have it disabled when i assign them to yellow leveler? Regards e33et No, when you describe the issue it sounds as if you have it turned off already. Turning it on might help, then the levers should take the same position as your hardware controls (in your case that would mean the engines would slow down to idle when starting with engines running, if not putting your hardware throttle at the right position directly). Helicopters and Viggen DCS 1.5.7 and OpenBeta Win7 Pro 64bit i7-3820 3.60GHz P9X79 Pro 32GB GTX 670 2GB VG278H + a Dell PFT Lynx TrackIR 5
Recommended Posts