Jump to content

Recommended Posts

Posted

I've been using the saitek software for a few months, not too many issues.

 

I am now having problems where it is dropping out, for instance I load up and confirm profile is correct, enter dcs and I don't get a response, so then I go back in to saitek and send to joystick again, which works for a bit then drops out again. The profile is still the same and has not reverted back to default

 

Any ideas, I'm thinking of just wiping everything.

 

Sent from my SM-N960F using Tapatalk

Posted

Never had such issue, I been using SST since 2 years with my X56.

 

Nokia 6.1 with Tapatalka

Take a look my mods :joystick: 

dcs_footer500.jpg

CPU: i7 7700 | GPU: GeForce GTX 1080 8GB DDR5 | Motherboard: ASUSTeK PRIME B250M-A | RAM: 2x16GB DDR4-2400 | Output: Kingston HyperX Cloud II | Edifier C2XD 2.1 | Controlls: Saitek X-56 Rhino | Saitek Flight Rudder Pedals | Saitek Multi/Radio/Switch Panels | Thrustmaster MFD Cougar | Elgato Stream Deck XL | OpenTrack with LaserClip | VoiceAttack with VAICOM Pro plugin

 

Posted

That's good to know, I think I'll reinstall everything and go from there.

I must say I love how there are so many possibilities with this software.

 

Sent from my SM-N960F using Tapatalk

Posted

You may like it:

 

Nokia 6.1 with Tapatalka

Take a look my mods :joystick: 

dcs_footer500.jpg

CPU: i7 7700 | GPU: GeForce GTX 1080 8GB DDR5 | Motherboard: ASUSTeK PRIME B250M-A | RAM: 2x16GB DDR4-2400 | Output: Kingston HyperX Cloud II | Edifier C2XD 2.1 | Controlls: Saitek X-56 Rhino | Saitek Flight Rudder Pedals | Saitek Multi/Radio/Switch Panels | Thrustmaster MFD Cougar | Elgato Stream Deck XL | OpenTrack with LaserClip | VoiceAttack with VAICOM Pro plugin

 

Posted

All I needed was a Powered USB hub. I didn't realise.

 

It's like a new joystick again!

 

It takes a lot of stick, no pun intended. But I think it's good stick and with the software it's pretty amazing.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...