Thrusrmaster Hotas - Not recognising thrust increase/decrease

[RR19VLR]

Am over the moon with my recent Slew sensor upgrade, if you haven't done it yet, I recommend it. However, since doing this I have an annoying issue where I cannot increase or decrease thrust?

 

I'm sure this is isn't related to the slew sensor.

 

While flying, all switches visibly move in the cockpit. When I open the Thrustmaster software, it recognises the action of thrust increase and decrease. But, when in game, I simply cannot get it to recognise the movement... I have been using axis commands and when after clearing the thrust I try to rebind and it does not accept any movement.

 

Does anyone have any ideas that may be able to get back up in the air?

 

Thanks in advance. Stay safe.

[Dreadwing]

Are your clicking "axis assign" at the bottom? If trying to click then move the axis to bind I don't know if that will work. You need to click axis assign at the bottom and choose the appropriate one for the throttle levers, which for the warthog I believe are Z and rZ.

 

Sent from my SM-N975U1 using Tapatalk

[Gruman]

You had to calibrate the throttle after installing the slew replacement. Did you calibrate all the axes properly?

[BJack]

 

While flying, all switches visibly move in the cockpit. When I open the Thrustmaster software, it recognises the action of thrust increase and decrease. But, when in game, I simply cannot get it to recognise the movement... I have been using axis commands and when after clearing the thrust I try to rebind and it does not accept any movement.

 

Does anyone have any ideas that may be able to get back up in the air?

 

Thanks in advance. Stay safe.

 

 

I have not done the slew upgrade and I have the same problem. Thrustmaster HOTAS Warthog Throttle is not being reconized by DCS. It works fine in T.A.R.G.E.T Device analyzer.