Gunfighter 2 Pro extension springs

[Uxi]

Finally got a pipe welded to the arm plate on my chair so switched from my desk on the table mount to the pro mount on a VESA camera arm. Used #50 and a #30. This should be safe right?

 

Everything seemed to work though hard a bit of a fun time making sure it was tight enough since the first time started getting erratic button presses and noticed the red light flashing so tightened it up good but always worried might be putting a bit too much on it. So far everything seems good... other than needing to relearn a bunch of muscle memory ingrained from the last 6+ months...