Ant0ine Posted June 11, 2020 Posted June 11, 2020 Ok, now it,s works fine. The problem was the order of the axes maping as you said. Lots of thanks, you have helped me a lot. I am happy with the Target but I will test gremling soon. Once again, thanks! Note that you can use Gremlin on top of Target.:thumbup:
pabletesoy Posted June 12, 2020 Author Posted June 12, 2020 Some questions about Joestik Gremling: -Some buttons that in the Target have two outputs in the Gremlin only have one, for example the APDIS / APENG button, or the EACOF / EACON switch. In the case of BSB / BSM / BSF in Target there are three and in Gremling there are two buttons ...is there any way to got them in Gremling? - can you JG manage the LEDs of the Hotas? Thanks!
Ant0ine Posted June 13, 2020 Posted June 13, 2020 - can you JG manage the LEDs of the Hotas? No you can't control the led with Joystick Gremlin, however you could use Joystick Gremlin on top of a Target Profile to get both. -Some buttons that in the Target have two outputs in the Gremlin only have one, for example the APDIS / APENG button, or the EACOF / EACON switch. In the case of BSB / BSM / BSF in Target there are three and in Gremling there are two buttons ...is there any way to got them in Gremling? In Target GUI we see the off position of the switch, so we can map them directly. To do that in Gremlin we have to use 'MACRO' and set 'condition'. Here is an exemple : https://imgur.com/a/T7y4gwx Another one here on the flap switch : https://imgur.com/a/96Hifh7
pabletesoy Posted June 15, 2020 Author Posted June 15, 2020 Ok, I will go on with Target but I do not rule out the JG, it is very intuitive. Thank you! Very good help!
Recommended Posts