[BUG] Post-repair hydraulics, no FLT hydraulics and Hyd Press light still on

[LanceCriminal86]

During a strafe run, I took a few hits to the fuselage and it appears lost primary FLT hydraulics. On the right needle it was zero but the left/comp hydraulics were still good, tried to flip the hydraulic bypass on as soon as I saw it but I guess the system was completely drained or dead already. Aircraft flew as normal, landed it at Kutasi. Parked the aircraft, turned off the engines, and requested repair. 170 seconds later, bullet holes all gone. Go to start up the aircraft, and the right hydraulic needle stays dead. Shut down, request repair again, nothing. Start back up, still dead. Hyd Press light still illuminated and FLT HYD still pegged at zero with both engines running. Tried doing the hyd bypass switch, nothing changed there. Nothing with emergency hyd in high or low either.

 

I tried to save a track but got an error about how it couldn't read the temp file for the track.

 

Mission log shows these failures after the hit:

 

INS : Total

INS : Nav Computer

RWR : 315 quad receiver/antenna

Edited June 26, 2020 by IronMike

[FoxTwo]

Yeah this is an old bug. I think if you lose the hydraulic fluid, it's not modeled to be replaced during a repair.

[LanceCriminal86]

Yeah this is an old bug. I think if you lose the hydraulic fluid, it's not modeled to be replaced during a repair.

 

Interesting, first I'd encountered it. I've been skinning not flying lately so hadn't encountered it myself. In the past if I got hit that bad and landed I didn't know how to properly get Jester to redo the INS alignment so I never did a repair.

 

Realistically if you get all shot to hell the bird's done but that sucks for the persistent missions or MP.

[IronMike]

Thank you, added a tracker.