[REPORTED EARLIER] ACM fails to reset elevation.

[OB1]

I'm not sure it this is intended or not but it doesn't seem right to me.

 

For example if you change your radar elevation in any mode.. lets just say RWS to point strait down, then switch to any ACM mode, boresight for example. You will be unable to pick up a target inside your boresight circle as it is actually offset to point down at the same declination as what you had it in before you switched to ACM mode. I would have thought ACM would re-center your elevation.

 

Is there a way to manually re-center the elevation without exiting ACM ?

[Harker]

It's a bug, it's been reported for a while now.

 

Also, if you change elevation, it'll offset the azimuth of the vertical scan, also a bug.

[OB1]

ah ok thanks !