Ka-50 | Possible Trim Issue After Repair

[Devrim]

Hi.

 

Problem question: When Ka-50 repairing, is it possible to miss out zeroing trim?

 

Story: Last week, in Aerobatics Online Server, those happened respectively:

 

> I landed on the helipad. There was a little forward trim on the cyclic.

> Then, a F-18 crashed very close to me. My aircraft damaged badly and I requested "repair".

> My Ka-50 was repaired and I started up the AC. I trimmed a little forward and took off.

 

Problem: At that time, I realized that there was too much forward trim, I did reset trim and, voila! I got balanced trim like before repairing.

 

Is there anybody experienced this?

Thank you.

[Baaz]

To my knowledge, this has always been the way.

 

The repair does just that; it repairs the aircraft. It does not reset the aircraft to it's default start condition. You will notice if you just do a default LWin+End shutdown, and then repair, not all switches are returned to default start.

 

Therefore, upon landing, since you did not reset trim after touchdown, after repair you will still have the trim set as it were at touchdown.

[Devrim]

Ok, got it but, then that means we have another bug: After repair, I see the trim diamond at the center. It looks like it has been reset. Contrary, the Control Indicator should show me the trim diamond's position where I left.