F16FLCS-SME Posted November 13, 2020 Posted November 13, 2020 Use your mousewheel to move the pitch or roll thumbwheels to its mechanical stop. The white zero trim line on the thumbwheel disappears soon after the thumwheel is rotated so the line is inside the panel. That range is too small. The range should be that the white line can be barely seen in the opposite end of the trim direction, slightly below the edge of the panel. So if you trim the roll to full LWD, the white line should appear at the edge of the RWD. The range of motion is approximately 270 degrees to each direction from center (zero trim). Fully reproduceable so no track file needed. As a reminder, I used to repair those panels for a living.
Recommended Posts