bruennlein Posted February 17, 2021 Posted February 17, 2021 Hi guys, I´ve connected 2 Tablets via SpaceDesk and set the monitor-setup to 3 monitors. Now the whole application is a small bar in the middle and I´m unable to reach the OK-button in the setup-screen. I can set it back to single-monitor, but without OK-button, I cannot confirm. There should be some kind of recovery. The aspect-ratio was set automatically and looks a bit weird. The screenshot shows my entire 23" 1920x1080 display. Best regards...
bruennlein Posted February 17, 2021 Author Posted February 17, 2021 I could help myself with a workaround. This is, what I did: Open the folder, where DCS is located in go to Config\MonitorSetup Make a backup of the settings-file which corrosponds to your selected monitor-setup (in my case 3Cameras.lua) Open 1Camera.lua and copy all the content Open the settings-file which corrosponds to your selected monitor-setup (in my case 3Cameras.lua) and remove all content... ...then insert the content of 1Camera.lua Save the file Start DCS (Application shoul be expanded over the whole screen again) Go to the setup-screen and fix your setup by selecting the values, you want to have Copy the backup of the overwritten file (from step 5-6, in my case 3Cameras.lua) back to Config\MonitorSetup in yout DCS-directory to repair the 3-screen setup MOST IMPORTANT!!! --> Take a breath and anjoy flying @ED: Being unable to recover broken settings from the UI and being forced to mess-around with the config files is still a bug! So guys, your not reliefed Happy bugfixing!
Recommended Posts