Jump to content

Recommended Posts

Posted

I hope this is the correct place to bring this issue up.  I programmed one of my F/A-18C cockpit switches to operate the LST/NFLR switch using DCS BIOS and my Elegoo Mega 2560 board (pin 2); when I am in the sim it operates the  FLIR switch.  Every time that I cycle the OFF-ON switch it moves the FLIR switch from OFF to STBY to ON then stops.  I have included both the DCS BIOS control input section along with my Arduino sketch to see if it is my issue or a DCS BIOS issue.  Everything else is working flawlessly.  Thanks again to those that created the DCS BIOS program.

 

Thanks,

Wayne

Arduino Sketch Com5.jpg

DCS BIOS LST-NFLR Switch.jpg

Wayne Wilson

AKA: hrnet940

Alienware Aurora R3, i7 3820 3.5GHz(4.2GHz setting) processor, EVGA Nvidia RTX 2070 8GB Graphics, 16GB Ram, 1TB SSD.

  • 1 year later...
Posted

Did you ever manage to work this out? I just finished making a right side panel and i have the same issue i am using DCS bios and every time i move the LST/NFLR switch it doesnt move, but it will move the flir switch from off to stby to on. i also have the Flir switch wired and and this works fine on it's own? no other issue with other panels on right side. 

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...