hrnet940 Posted April 28, 2021 Posted April 28, 2021 I hope this is the correct place to bring this issue up. I programmed one of my F/A-18C cockpit switches to operate the LST/NFLR switch using DCS BIOS and my Elegoo Mega 2560 board (pin 2); when I am in the sim it operates the FLIR switch. Every time that I cycle the OFF-ON switch it moves the FLIR switch from OFF to STBY to ON then stops. I have included both the DCS BIOS control input section along with my Arduino sketch to see if it is my issue or a DCS BIOS issue. Everything else is working flawlessly. Thanks again to those that created the DCS BIOS program. Thanks, Wayne Wayne Wilson AKA: hrnet940 Alienware Aurora R3, i7 3820 3.5GHz(4.2GHz setting) processor, EVGA Nvidia RTX 2070 8GB Graphics, 16GB Ram, 1TB SSD.
Danos Posted September 1, 2022 Posted September 1, 2022 Did you ever manage to work this out? I just finished making a right side panel and i have the same issue i am using DCS bios and every time i move the LST/NFLR switch it doesnt move, but it will move the flir switch from off to stby to on. i also have the Flir switch wired and and this works fine on it's own? no other issue with other panels on right side.
Recommended Posts