Picchio Posted July 25, 2021 Posted July 25, 2021 (edited) A question for those who own the CM3 throttle: in the VPC Configuration Tool, enable Debug mode and Calibrate Axes. Once you have moved all the axes and before saving the calibration, what Range values do you get for each axis? Please post a screenshot, so I can quickly compare mine. Thank you for your cooperation! Edited July 25, 2021 by Picchio
Picchio Posted July 29, 2021 Author Posted July 29, 2021 (edited) Well, since no one here replied, I figured I'd expand a little bit more: it would seem that the Range values I'm getting after each calibration are halved, confronted with the expected/normal values for rX and rY (at least 12000 -/+ 500-1000 points). I'm not entirely sure what is going on, perhaps someone here could provide some insight. Other than these seemingly abnormal value readings, everything else seems to work fine, as far as I can understand... I'm attaching the calibration result for my Base and Pedals as well. N.B.: All devices are plugged into a powered usb hub. Plugging them directly to the motherboard doesn't change. So far, when diagnosing the CM3 Throttle (we examined that alone because I was encountering other issues), Support concluded that PCBs for rX needed to be replaced. Assuming this is valid and therefore something is up with the sensors, then even Base and Pedals are messed up... ? I'll appreciate every suggestion. Update: response from Support is that Range values are individual. It's not clear to me if and how these values reflect the sensor's output resolution, or why they are so different even between the same device. In any case, I'll have to wait for the spare parts to arrive, and see how it goes. Edited July 29, 2021 by Picchio
Recommended Posts