Captain Orso Posted July 28, 2021 Posted July 28, 2021 Pressing and holding <Right-Shift><Insert> causes the Priming Pump plunger to constantly cycle between locked and unlocked. The same behaviour is of course seen when assigning a switch to the bind, and since the single On and Off binds were written with "pressed" instead of "down", and there is no opposite of "pressed" defined in DCS, there is no way to assign locking and unlocking the priming pump handle to a switch that works reasonably. Anyone have a solution to this? When you hit the wrong button on take-off System Specs. Spoiler System board: MSI X670E ACE Memory: 64GB DDR5-6000 G.Skill Ripjaw System disk: Crucial P5 M.2 2TB CPU: AMD Ryzen 7 7800X3D PSU: Corsair HX1200 PSU Monitor: ASUS MG279Q, 27" CPU cooling: Noctua NH-D15S Graphics card: MSI RTX 3090Ti SuprimX VR: Oculus Rift CV1
Recommended Posts