Jump to content

Recommended Posts

Posted

Prior to the last DCS update there was  a change in the sensitivity of my TMWH joystick primarily in pitch. 
 
Previously I had pitch set with a curve of +10 and was routinely able to gain sniper shots on the cockpit of AI aircraft. I have tried changing the curve to as much as +60 but even the most gentle of touches causes the pipper to over correct even against a stable turning AI. I now have the curve set to +15 which allows normal control of flight in terms of general handling and landing of my F16, but guns dogfights remain problematic particularly with manoeuvring AI in a fight.

 

I am not aware of any other software/driver updates which may have caused the change in sensitivity. However this may be possible. 
 

Given I understand the use of curves and believe I have at least a skill level to hold the pipper on target under normal circumstances- Can anyone offer some advice on where the issue may be rooted? I have run a DCS repair and reinstalled the TMWH drivers. 
 

Many thanks in advance 

Ryzen 9800X3D, MSI  RTX 4090, 4 TB SSD, 64GB 5200 MHZ DDR5 RAM, MSI 670E Motherboard, Pimax Crystal. Buttkicker Plus, WINWING Rudder Pedals & F16EX Throttle: FSSB-R3-MKII ULTRA Base/TMWH Joystick: DCS: F16C. 

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...