Rei.BleacH Posted January 17, 2022 Posted January 17, 2022 Hi guys, I need some information on how to use VIP because, every time I insert it it always goes to steerpoint 1 while if I use the VRP it works perfectly how do i get the VIP and POP on steerpoint 3 for example?
Frederf Posted January 18, 2022 Posted January 18, 2022 Hmm, there are a few things wrong with this. There are two VIP DED subpages, the page for setting VIP-TO-TGT and another page for VIP-TO-PUP with a SEQ between them. The second line which has VIP * #*↕ on each page should always be tied together in value. Currently it's possible to set them to different numbers with very weird results. The active steerpoint is shown on the CNI page. It should be the case that VIP behavior is only displayed when active steerpoint = VIP steerpoint as selected. Currently the PUP is only shown when active steerpoint is 1 regardless of the VIP selection on either VIP DED subpage. The PUP is only showing when the current active steer is 1 but it's showing relative to the steer chosen on the PUP DED page. Similarly the TGT is shown correctly offset from where the assigned IP is only if active steer is 1. The diamond showing the IP only shows correctly when the IP DED page point selection is also 1. It's terribly broken and wrong but you can get VIP attacks on your desired steerpoint by doing the following: Current steerpoint 1 VIP-TO-TGT VIP 1↕ VIP-TO-PUP VIP #↕ Where # is the particular steerpoint you want to reference for the attack. This applies regardless of whether you use PUP or not.
Recommended Posts