Rudder Throw - How to Configure?

[Mistermann]

Let me start by saying I know this is a “me problem”.  I just can’t seem to figure out how to resolve it. 

My VKB rudders are connected to same black box as my MCG Ultimate Pro.  Everything is working great – except I get far too much rudder throw in the sim from the physical movement of the pedals.

Can someone please help diagnose this problem and suggest a “fix” for me?

I want to get a directly proportional movement in the sim as I do from the pedal.  Press the left pedal in 50% and I should see a 50% movement of the left pedal in DCS.  Pressing the pedal to the floor should result in full movement of the DCS rudder.

Unfortunately, I am not getting that behavior.  Instead, I only have to depress the pedal about 20% to reach full movement in DCS.  This is making the anti-torque extremely sensitive.  I’m playing with it like that and can cope, but it would be SO MUCH EASIER if the DCS movement was directly proportional to my foot movement.

I have not messed with the VKB Device config software in regards to the pedals.  My “spidey senses” tell me my solution resides somewhere in that complex mess of configuration confusion.  I suppose if I can power through the configuration experience for the MCG, the pedals should be a walk in the park.  I just don't know how or where to start ...

My VKB Device Config has the pedals on Axis #7 and has the following setting

I have DCS setup with the following Axis tune

 

Any help here is greatly appreciated.

Thanks!

[Mistermann]

I got an answer over on VKB's site and will post here.  I needed to recalibrate my entire stick and rudder combination.  Problem solved.  No programming.