Tenrai Posted January 5, 2009 Posted January 5, 2009 (edited) Hey guys, I recently swapped my X-52 stick for a CH fighterstick. Keeping my x-52 throttle, this setup works just fine in LOMAC. However when I swap to ArmA, it does not receive any input from the CH stick whatsoever. Joystick is enabled, when I try to configure the stick ingame. None of the axis' or buttons give any response ingame. I've tried loading a clean profile in direct mode and I've tried it without anything loaded. The calibration still displayed that everything worked. It's just in ArmA that I don't get any response. The X-52 throttle works just fine ingame. I hope you guys have a solution for me. Any help is greatly appreciated. Thanks in advanced. Edited January 5, 2009 by Tenrai
DarkWanderer Posted January 5, 2009 Posted January 5, 2009 Did you try disconnecting the throttle, having only fighterstick plugged? You want the best? Here i am...
shadowze Posted January 5, 2009 Posted January 5, 2009 Arma only allows 1 input device ( joystick etc ) So you cant mix n match sadly
Tenrai Posted January 5, 2009 Author Posted January 5, 2009 Arma only allows 1 input device ( joystick etc ) So you cant mix n match sadly Ahh, such a bummer. Thanks a lot though. Guess I'll just bind the throttle on the stick.
104th_Crunch Posted January 5, 2009 Posted January 5, 2009 If you had a CH throttle, you could make the CH stick and the CH throttle appear as 1 device and have them both work in ArmA.
Recommended Posts