Cerppo Posted September 17, 2022 Share Posted September 17, 2022 Hi, Working on this project I noticed some strange things on the CDU in the A10C2. From SYS Page. Page 1 : EGI page is not reported to DCSBIOS ? Page 1: LASTE then WIND , the Temp near ***/*** is not reported at the correct position on dcsbios ? (just in front of WNDEDIT ), same when you press WNDEDIT again Page 2 : Press MXLOG lower right , MXLOG page is displayed correctly on the CDU, but a different page is reported on the Right MFD? (shows CADC page instead ) FPBuild , the page number right to scratchpad is not send to DCSBios ( by the way, i also made a AH64 use of this ) Link to comment Share on other sites More sharing options...
Recommended Posts