Jump to content

Recommended Posts

Posted

Hello all.

I am hoping someone has some advice on working with DCS-BIOS defineRadioWheel and DCS .lua files using function radio_wheel_1. I have written a sketch for Mi-24P JADRO radio for Arduino which successfully sends correct numbers to SOCAT, and shows them being changed by the dials I am turning. (These are authentic JADRO dials, using analogue binary codes by switches, and the output is being read on the Arduiino using Port Registers). 

But, I cannot get those numbers into DCS in the sim. The sketch is communicating with the sim, as ordinary multi position switches are working, and activated in virtual cockpit when turned on. 

So, I am looking for some help with how to get the message and attached integer/character to be read by DCS. The A10C uses a similar radio coding in DCS .lua, so I tried setting up a sketch to use the physical JADRO dials to work with the A10C. Still get the same problem.

Any guidance or experience with those radio_wheel_1/defineRadioWheel aspects will be greatly appreciated!

SCAN Intel Core i9 10850K "Comet Lake", 32GB DDR4, 10GB NVIDIA RTX 3080, HP Reverb G2

Custom Mi-24 pit with magnetic braked cyclic and collective. See it here: Molevitch Mi-24 Pit.

 

[sIGPIC][/sIGPIC] www.blacksharkden.com

bsd sig 2021.jpg

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...