Captain Orso Posted November 2, 2022 Posted November 2, 2022 This is making me insane. Mission is on Normandy map, with FW-190-A-8's attacking an airfield and Spitfires scrambling from another airfield to defend. If I set the attacking air group to Ground Attack, I cannot designate the defending AAA units as a target, only static objects. The AAA are somewhat dispersed, so it is impractical to designate each location individually, and have the entire group attack each one, one after the other I can set the 190's TASK to CAS and then set the AAA as the target (although it's absolutely not a CAS mission), but the attacking 190's often ignore the AAA targets and go after other targets; I'm not even going to start in about trying to get them to divebomb, because it's impossible .... no I wasn't going to go there. Setting TASK to CAS I can get the 190's to ground attack first the AAA and then parked P-51's (late activation, not static), but when the Spitfires arrive, the 190's refuse to engage them. They just fly around in circles and try to avoid getting shot(!!) Setting the TASK to CAP and the 190's will attack the Spitfires when they arrive, but it's impossible to get them to do ground attack before the Spitfires arrive Anybody know a solution? When you hit the wrong button on take-off System Specs. Spoiler System board: MSI X670E ACE Memory: 64GB DDR5-6000 G.Skill Ripjaw System disk: Crucial P5 M.2 2TB CPU: AMD Ryzen 7 7800X3D PSU: Corsair HX1200 PSU Monitor: ASUS MG279Q, 27" CPU cooling: Noctua NH-D15S Graphics card: MSI RTX 3090Ti SuprimX VR: Oculus Rift CV1
Recommended Posts