CM3 Base setup

[Turd Ferguson]

Would owners of this base mind sharing how you've got it set up please?

 

I have the base and the 200mm extension. I use the VFX grip for the F-14 of course and then the TM Warthog grip for the Apache, Huey.... well everything else and it's attached to one of Virpil's long desk mounts

 

When I first got the base at the end of November I didn't buy the extension. While using the soft spring and the no centre aviation cams it felt great for the Apache, was happily holding level flight at 90 ft over the desert and using the smallest amount of pressure fore and aft to change altitude if required something I never managed to do with the Warthog base.

 

I've since bought the curved extension too and like the extra travel but really can't dial it in. My hovers were ok previously but no matter how much i've changed the Cams, Springs, Curves, Saturation I can't find the sweet spot anymore. I'm hoping some of you can share your setups then I can use them as a starting point to get back to something passable.

 

As far as the F-14 goes I find i'm ok-ish, although it's quite twitchy just off centre so maybe the curves are too high, again hoping for a starting point to try to get back to where I was with the Warthog.

 

Thanks