Throttle sync issue/question

[Despayre]

Not sure if this is a module, or DCS, issue, (or neither?) but here it is...

Jumping into a cold plane, until my throttles are pulled back past the idle detent, they are not in sync with the cockpit, and moving them around does nothing (until pulled all the way back to off, then  they work normally). However, when jumping into a hot plane the throttle is immediately active (happened to be in AB when I left my previous plane, [possibly very unexpectedly dammit!])... by the time I was situated in the cockpit, the plane had already moved several 100 ft... and Andersen Tower was asking me all sorts of legit questions... like "Where are you?" and then "how did you get way over there?" and "why did you just cross an active runway?" ... Towers smh... those guys need decaf, but I digress...  

Is this the expected behaviour for the throttles? Shouldn't it be one or the other all the time? IE, throttles should remain disconnected from the controls, until they are positionally in sync to start with regardless of engine state?

Edited January 22, 2023 by Despayre
spelling error only.

[MAXsenna]

Have you selected "sync with HOTAS" in DCS settings or not?
I have, but I still get some strange behavior in some modules.
But not in the Tomcat, as long as I remember to put the levers to where they're supposed to be at mission start.
Warthog throttle.

Sent from my MAR-LX1A using Tapatalk

[Despayre]

5 hours ago, MAXsenna said:

Have you selected "sync with HOTAS" in DCS settings or not?

 

I do. Are you suggesting I should try without it?




 

 

[MAXsenna]

 

Yeah, just as a test, to if there is any difference.

Sent from my MAR-LX1A using Tapatalk