[BUG] Neither manual nor automatic Go-around mode trigger work correctly during Phase2/3 (OB MT)

[Snappy]

Hi,

unfortunately the go-around modes are completely missing or bugged. According to the manual, there are two ways of initiating a go-around during approach phase 2 or 3.  From Manual page 158:

1.) automatic go around , by turning away more than 90 degrees from the extended centerline of the approach.(only available during TILS approaches.)

2.)by manually switching master mode selector to NAV and back to LANDN NAV.

Neither of this works in the current DCS version. I attached two tracks.

In Track "ViggenGAby90DegTurn" I turn more than 100 degrees away to the right after being in Phase 3 during a TILS approach. The Go-around detection does not work, instead of new lateral guidance to waypoint LB for another approach, waypoint  LF stays the destination waypoint and the original approach guidance continues.

In Track "ViggenGAmanual" I wait until I am in Phase 2 , close to Phase 3 on final course towards Point  LF and then I manually switch the master mode selector to NAV and back to LANDN NAV. 
Again, no go-around guidance to a new approach via LB , instead the guidance simply continues for the approach I flew before.

Hope the tracks play out alright. I also attached the mission file, should it be needed for the tracks.

Kind regards,

Snappy

 

ViggenGAby90DegTurn.trk ViggenGAmanual.trk M06 - Landing - Clear Sky.miz

Edited May 15, 2023 by Snappy

[Silhou]

Hey Snappy!

Thanks a lot for your report. I've tracked it internally as AJS37-362.