BaronVonVaderham Posted June 17, 2023 Posted June 17, 2023 Just tried the bronco training. First lesson (start taxi and take off). I found the following problems: 1) toe brakes using rudder axis don’t work. I assigned the left add right brakes the same as my other aircraft, but it only wants to turn hard right when taxiing. It doesn’t behave like this with the key board. I did notice that key strokes are incremental (meaning I need an equal opposite brake key stroke to level out the braking. ). 2) can’t click the canopy to close it. The instructions don’t actually call it to close it either. 3) accelerates fine on the runway, but when pulling the toe at 100kts, it climbs brush and then is stuck. Meaning, I set nose trim to 10 degrees, but IT won’t climb out. If ahah won’t speed up any further. Mind you, I retracted the flaps and gear at about 110 or 120 kts 4) tried to turn back to the field, but immediately started buffering as if doing a stall turn. I pulled a little harder and it did stall into the ground. i don’t think these are normal behaviour for a twin turbo prop. Are these known issues?
Recommended Posts