Trim and Auto Hover no longer works

[Ramstein]

Please delete post..

 

all fixed now.. had no idea what was wrong, but it took a few hours to work on it..

Nevermind, problem has changed..

==================================

it appears my Saitek stick and/or rudder pedals are screwing up.

 

what a mess finding the problems

 

 

The'A' button my my Saitek X52 Pro is flashing red when I use the stick in Black Shark. The the button would cahnge to orange. If I pressed my 'i' button on my joystick throttle, it chages to red.. then if I pres sit again, and hold it it would be be green, until I let go...

 

That button is my Auto Hover with shift-state on. It worked fine the last 2 months. That button should only be a green light.

 

Trim stopped working from keyboard and joystick. I unplug the joystick and trim still no longer works. Auto Hover also no longer works I am afraid I have to completely uninstall Black Shark and reinstall it!

:cry:

Edited March 1, 2009 by Ramstein
problem fixed

[Shrubbo]

You don't have a wheel plugged in anywhere do you?

[Vesperatus]

I dont know if it could be related but I had some strange issues while playing Fallout 3 with the guitar hero guitar plugged in. I supposed it was acting strange since fallout was designed for xbox and the guitar is an xbox controller .... but whatever, unplug everything except you mouse and keyboard. It solved a couple of my input issues in the past.

[Ramstein]

It was very late and decided to fly a bit to see if I had some issues left over from yesterday with auto-hover. Well, it al went bad, then after a couple hours of plugging and unplugging my joystick pedals, and trying to fly, it is all fine now. I stil cannot figure out what went wrong. I went into my controller settings too. The part where it has my Saitek pedals had the same commands as my joystick and keyboard, which I ddin't hink it should. I tried to delete that stuff. In the past that was not needed. I kept backups the last time everything worked perfect, so I installed the backups:

 

E:\Black Shark\Bak\Config\Input\Aircrafts

 

these files:

 

E:\Black Shark\Bak\Config\Input\Aircrafts\ka-50\joystick

E:\Black Shark\Bak\Config\Input\Aircrafts\ka-50\keyboard

 

and the files in the directories.

 

at first that did not help. I stil do not know if that was a problem, but I did not get a snapshot of the controller when it had lots of those commands ( not all, but several groups) in the rudder section.

 

In any case, I hope it's fixed and whatever went wrong does not happen again..

Edited March 1, 2009 by Ramstein