gibilator Posted August 20, 2023 Posted August 20, 2023 Hi, The CM3 controller appears and is editable just fine in VPC-JOY-20230328. But creating the profile doesn't create a controller in the "Game Controllers" so its not accessible from any sim. It is fully functional as I have checked all the buttons and can assign LED colors etc with good power being supplied. I had this working on a prior format but when I built this PC I installed a later version of the VPC-Joy software and it updated the firmware. I have tried resetting the windows name/calibration. Not sure where to go from here. Any ideas would be appreciated. Cheers.
MAXsenna Posted August 20, 2023 Posted August 20, 2023 Try to open control settings and press "rescan", might help.Cheers! Sent from my MAR-LX1A using Tapatalk
Guest Posted August 21, 2023 Posted August 21, 2023 I think that the issue might be in USB port in the motherboard or USB hub. So try connecting the CM3 to other USB ports, preferably without USB hubs.
Guest Posted August 21, 2023 Posted August 21, 2023 Also, you could try changing CM3's ID. BTW you can do that inside virpil soft, Profile tab.
OziasMidwinter Posted December 15, 2023 Posted December 15, 2023 I had a similar problem with a TM Cougar TQS when used with a USB hub. I Also ran an arduino LED clock off the same hub, with the clock plugged in the Windows game controller would not detect the TQS, but with the clock disconnected the TQS was detected. I'm guessing that the clock was drawing a fair bit of power from the hub and it was preventing the TQS USB interface working correctly, either that or windows didn't liked having multiple micro-controller devices on the same hub (the TQS has been modified with a arduino micro-controller to turn it into a standalone USB device instead of connecting through the Cougar joystick.) I'd trying disconnecting any other devices from the hub, or try connecting the CM3 directly to the PC
Recommended Posts