Central Position Trimmer Mode Bug - Force Trim Hold Mode Switch - R/Up

[DarkRayler]

Greetings,

In 2.8 when i pushed the R/Up button it's locked my new trimmed center, in 2.9 when is push the trim button the red cross is moving to the right place but the center is still the old center. Any idea?

I tried all the 3 trimming method but same happend.

Thanks!

[DarkRayler]

The pedals trimming is working, but the cyclic trimmer mode not.

[Floyd1212]

We have seen this in the past for some users:

 

[DarkRayler]

Thanks, but still wont work...
I tried:

• AH64 module remove/reinstall
• remove all my settings (reset all AH64 settings, inputs etc.)
• Updater Cleanup, slow repair
• Remove/Reinstalling the whole game
• binding vr motion controller, xbox controller

but always the same, so i really cant use the ah-64 now.

Any other option?

 

 

[Chops]

I am having the same issues.  After pressing and holding the force trim button and releasing it after stabilizing the helicopter in pitch and roll, it will pitch up.  Also, after stabilizing the helicopter and tapping the force trim button it will oscillate in pitch.  Screenshots and track are attached.

Apache Trim Fail.trk

[DarkRayler]

 

 

As Shaman wrote the solution:

"I am experiencing the same issue with cyclic trim with 2.9.

In the control debug window it shows trim position has fixed in new position after use of force trim (trim hat), but it does not reduce forces on cyclic. Pedals force trim action seems fine.

I have tried both Immediate and Center Action settings.

 

Then I went to Options / MISC ... and "Force Feedback" check box was activated. Deactivated that option and it resolved this problem."

It solved for me.

[Chops]

I am still having the issues I mentioned above.  As shown in my screen shot I do not have Force Feedback enabled.  Can someone please look at my track and give me some feedback?

I have Virpil CM3 Throttle and the Virpil APC Stick.  I zeroed out the dead zones present in the Virpil Configuration Tool.

Thanks!