Schwamba Posted November 25, 2023 Posted November 25, 2023 Hello to all. I have a Constellation Alpha and the main trigger when pressed to the first detent does not always retract to the neutral position. It has to be Only when pressed to the second detent it fully retracts and even te not always. Any suggestions?
Guest Posted November 27, 2023 Posted November 27, 2023 Pretty sure its an uncommon issue that only virpil support can help you with. Just contact them. They used to be very helpful and quick to respond when I was talking to them in the past.
randomTOTEN Posted November 27, 2023 Posted November 27, 2023 There's a bolt and nut which hold the trigger into position (trigger rotates around it). Use an allen key to very carefully loosen the bolt. It sounds like it's too tight.
Guest Posted November 29, 2023 Posted November 29, 2023 On 11/28/2023 at 12:29 AM, randomTOTEN said: There's a bolt and nut which hold the trigger into position (trigger rotates around it). Use an allen key to very carefully loosen the bolt. It sounds like it's too tight. Good point. But it's only first ALPHAs that had a bolt and a nut. Later they were replaced by a pin that can't be adjusted.
randomTOTEN Posted November 29, 2023 Posted November 29, 2023 (edited) 4 hours ago, Qsenox said: Good point. But it's only first ALPHAs that had a bolt and a nut. Later they were replaced by a pin that can't be adjusted. Okay, well now I know I have an early build ALPHA *shrug* good luck otherwise... Edited November 29, 2023 by randomTOTEN
Schwamba Posted November 29, 2023 Author Posted November 29, 2023 Thank you very much. I'll give it a try. it's the first Alpha alright.
Recommended Posts