Jump to content

Caught up in Firmware update hell on my Orion 2 / F16EX


Recommended Posts

Posted (edited)

So, my F16EX and Joystick Orion 2 base both show the latest firmware update yet they still are requesting to be updated.  Any thoughts on how to get back on track ?

https://ibb.co/Bn1KXV0
https://ibb.co/r4L0FWt
https://ibb.co/pb9pQwd
https://ibb.co/Hqjqw0j
https://ibb.co/1Xhy7tD

 

 

 

 

Edited by Shack

Intel i9 14900K @5.5 MHz, 64GB DDR 5 RAM at 6000 MHz, RTX4090, Pimax Crystal HMD, HOTAS: Winwing F16EX / Orion 2 Throttle base / Top Gun MIP / F-16 ICP setup.

Genetrix JetSeat on a DOF Reality P6, 6 axis Motion Platform

DCS 8166.jpg

Posted

I was able to successfully update my ORION 2 joystick base, but when I reconnect the F16EX, both go to BOOT mode again ( needing firmware update ). 

Intel i9 14900K @5.5 MHz, 64GB DDR 5 RAM at 6000 MHz, RTX4090, Pimax Crystal HMD, HOTAS: Winwing F16EX / Orion 2 Throttle base / Top Gun MIP / F-16 ICP setup.

Genetrix JetSeat on a DOF Reality P6, 6 axis Motion Platform

DCS 8166.jpg

Posted
16 hours ago, Shack said:

So, my F16EX and Joystick Orion 2 base both show the latest firmware update yet they still are requesting to be updated.  Any thoughts on how to get back on track ?

 

Did my update for the UFC

'Finish' at 99.9% yesterday, got the same "Boot" message, ran another update over it, went to 100%, all seemed fine after that

Intel I5 13600k / AsRock Z790 Steel Legend / MSI  4080s 16G Gaming X Slim / Kingston Fury DDR5 5600 64Gb / Adata 960 Max / HP Reverb G2 v2

Rhino FFB / Virpil MT50 Mongoost T50 Throttle, T50cm Grip, VFX Grip, ACE Rudder / WinWing Orion2 Navy, UFC&HUD, PTO2, 2x MFD1, PFP7 / Logitech Flight Panel / VKB SEM V  / 2x DIY Bodnar Button Panels

DCS Juli 2025.jpg

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...