Klax75 Posted July 12, 2024 Posted July 12, 2024 (edited) I use my two Gladiator NXT EVOs. I'm disabled in real life in a wheelchair. Can't use pedals, use a omni throttle which works great for me. Now, not sure if it was yesterdays patch. When I use the stick twist from for left stick and right sticks for corresponding wheel brakes. Works good, but now when I use it after I stop pressure on the twist. The toe brakes in the sim don't return to zero pressure. They stay at 50% pressure. If I hit digital both brake buttons the will release and go to 0% pressure when I let go of the button and I can roll freely. As soon as I use twist toe brake that wheel goes brake to 50% press. So I can't taxing or take off. The number in control setup in DCS says they are at zero not drift. Edited July 12, 2024 by Klax75
MAXsenna Posted July 12, 2024 Posted July 12, 2024 I use my two Gladiator NXT EVOs. I'm disabled in real life in a wheelchair. Can't use pedals, use a omni throttle which works great for me. Now, not sure if it was yesterdays patch. When I use the stick twist from for left stick and right sticks for corresponding wheel brakes. Works good, but now when I use it after I stop pressure on the twist. The toe brakes in the sim don't return to zero pressure. They stay at 50% pressure. If I hit digital both brake buttons the will release and go to 0% pressure when I let go of the button and I can roll freely. As soon as I use twist toe brake that wheel goes brake to 50% press. So I can't taxing or take off. The number in control setup in DCS says they are at zero not drift. Axis settings. Only sticks should be left at default, because the have 0 position in the middle, and 100/-100 on either side. Axis like throttles, collectives, brakes and what not have got position from 0-100 and should be set as sliders, and might even need to inverted under axis tune. Hope this helps, and best of luck!Sent from my SM-A536B using Tapatalk
Klax75 Posted July 12, 2024 Author Posted July 12, 2024 On the stick the twist part recenter also, even when setting it as a slider. DCS Axis Tune Panel at the bottom it has number fields. When you mouse over them say type number value. But you can't enter anything. 1
Klax75 Posted July 12, 2024 Author Posted July 12, 2024 I think I got the left on to work the way I need it. The right one no. 1
Klax75 Posted July 13, 2024 Author Posted July 13, 2024 5 hours ago, MAXsenna said: Axis settings. Only sticks should be left at default, because the have 0 position in the middle, and 100/-100 on either side. Axis like throttles, collectives, brakes and what not have got position from 0-100 and should be set as sliders, and might even need to inverted under axis tune. Hope this helps, and best of luck! Sent from my SM-A536B using Tapatalk Thanks forgiving me the solution and idea. In the VKB software I just had to invert the right stick twist. 1
MAXsenna Posted July 13, 2024 Posted July 13, 2024 On the stick the twist part recenter also, even when setting it as a slider. DCS Axis Tune Panel at the bottom it has number fields. When you mouse over them say type number value. But you can't enter anything. As you probably noticed. Rudders must also behave like stick with centre. Apologies, forgot to mention that! Sent from my SM-A536B using Tapatalk
Recommended Posts