F1EE - How to add waypoints in Mission Editor

[omohat]

Is there some special process for adding INS waypoints in the mission editor for the F1EE?

When I add waypoints, the only waypoint the INS actually has is the aircraft starting position (verified because I can see the wide needle point behind me and the distance increases). The IDN is in NAV-N mode

When I select waypoint 2 and press * the distance in the IDN disappears (even though the INS display is showing waypoint 2). The wide needle points to 270 and the distance counter shows 999

What am I doing wrong (not doing) in the mission editor when setting up waypoints.

I've attached a mission showing what I've tried to setup (air start with 2 waypoints; i.e. should be three waypoints stored in the INS)

03 Caucasus INS ME Waypoint Test.miz

[kontiuka]

36 minutes ago, omohat said:

Is there some special process for adding INS waypoints in the mission editor for the F1EE?

03 Caucasus INS ME Waypoint Test.miz 38.85 kB · 1 download

I tried your mission and it works fine.  I can select all 3 waypoints and IDN reflects the proper bearing and distance to each.  Maybe attach a track file.  You might be missing a step in-flight.

[omohat]

2 hours ago, kontiuka said:

I tried your mission and it works fine.  I can select all 3 waypoints and IDN reflects the proper bearing and distance to each.  Maybe attach a track file.  You might be missing a step in-flight.

Ah ok. Let me RTFM again and re-try. I'll report back with a track if I still can't get it to work

[omohat]

4 hours ago, kontiuka said:

I tried your mission and it works fine.  I can select all 3 waypoints and IDN reflects the proper bearing and distance to each.  Maybe attach a track file.  You might be missing a step in-flight.

Ummm. DCS strikes again?

I did the exact same steps in-flight and the waypoints are working. Not sure what was happening before.