Stickler Posted January 12 Posted January 12 (edited) In the RL 34-1-1, the following WARNING can be found in the OFFSET RADAR IP section: There is also this depiction of an OFFSET/TGT FIND attack reproduced in the game manual that is slightly less specific: This strongly indicates that in LABS/WRCS modes, the AJB-7 pull-up command will be triggered when the aircraft is at a range from the inserted target position that is equal to, but not greater or less than the value set in the Release Range window. Various other paragraphs in the 34-1-1 also speak of a release signal being trigged AT a specific range instead of "at or above/below". This leads me to believe that when executing a Timed O/S WRCS attack without offset ranges set and subsequently FREEZING and TGT INSERTING directly over the target, the pull-up command should occur when the aircraft reaches a distance BEYOND the target which is equal to the distance set in the Release Range window. As the attached track shows, however, in the game this is currently not the case. Instead, upon TGT INSERT the AJB-7 pull-up command is triggered immediately, presumably because the distance between the aircraft and the target is LESS than the Release Range. tladd_rr.trk Edited January 14 by Stickler
Recommended Posts