Question about SimAppPro profiles

[rwbishUP]

I need to set a couple axis inputs over to switch type inputs for different aircraft. Is there a way to save the type of input an axis switch is set too, for each aircraft profile in Sim App Pro? For example, I need the slider to work as an axis in some aircraft. But, I need it to function as a switch in other aircraft. So, is it possible to save the type of input that controls are set to emulate, to each individual aircraft profile? And, not have to open Sim App Pro and change the type of switch input, every time I use a particular aircraft?

Edited Saturday at 10:36 PM by rwbishUP

[Dos]

Hello couldn't you use binding porfiles in DCS instead?

[rwbishUP]

16 hours ago, Dos said:

Hello couldn't you use binding porfiles in DCS instead?

Well, I like flying all of my modules pretty much equally. So, I don't map my HOTAS controls to match the actual air frame. I try to map them controlling the same features and sensors across the board. But, i.e. when you control the antenna in the Hornet & F-16 with an axis, they have a different behavior. The Hornets ant elev  will stay consistent with where you set it. But, the Vipers ant elev will stay synced with the axis, therefore snapping back to center when you release the axis that I'm wanting to use. So, I was just wondering if I could change the input type of this particular axis over to act as switches for the F-16. But, have it remain as an analog axis for the F-18? And it store those settings made in SimAppPro, to that particular plane profile. Like the old Logitech x56 app did. I was just curious about it, before I make a work around and use a different mapping strategy. I can't really find much info on Sim App Pro.