Bullseye Info Missing

[Polonsky]

Mission 05 features AWACS but I can't create/set an existing waypoint as bullseye for better situational awareness as it's not mentioned in the briefing or the keel board. 

[Scotch75]

Mission 05 features AWACS but I can't create/set an existing waypoint as bullseye for better situational awareness as it's not mentioned in the briefing or the keel board. 

I think WPT59 will always be the default Bullseye from the mission file.
Cheers!


Sent from my SM-G998B using Tapatalk

[Looking Glass]

Thanks, will check this out

[Polonsky]

12 hours ago, Scotch75 said:

I think WPT59 will always be the default Bullseye from the mission file.
Cheers!


Sent from my SM-G998B using Tapatalk
 

I've heard things like this but there's no wpt 59 in the data page of HSI

[Scotch75]

I've heard things like this but there's no wpt 59 in the data page of HSI

Hhmm, there should be. Keep pressing the Down arrow button. You'll go below WPT0, through the 9 Mark points (M9->M1), then you should hit WPT59.
Cheers!


Sent from my SM-G998B using Tapatalk

[Polonsky]

On 9/1/2025 at 9:12 PM, Scotch75 said:

Hhmm, there should be. Keep pressing the Down arrow button. You'll go below WPT0, through the 9 Mark points (M9->M1), then you should hit WPT59.
Cheers!


Sent from my SM-G998B using Tapatalk
 

I've tested just know and it works but sometimes I can't switch beyond WPT0 to get MK9-0 and ultimately WPT 59, instead it will loop back to the last WPT defined. Not sure what I've done wrong in those cases

[rob10]

10 minutes ago, Polonsky said:

I've tested just know and it works but sometimes I can't switch beyond WPT0 to get MK9-0 and ultimately WPT 59, instead it will loop back to the last WPT defined. Not sure what I've done wrong in those cases

UNBOX the SEQ in the bottom right hand corner of your SA or HSI page.  When boxed it will only allow you to cycle between WP's that are part of that sequence (which can't include markpoints).