AFCS test fails with G940 FFB

[VANOIS]

Sorry, if this has been discussed before, but I'm having a terrible time with this.

I can't complete the ACS test on the MiG-29, if the joystick has FFB. I turn on the ACS, and the virtual stick and the real stick (Logitech G940 joystick with force feedback) start moving. At some point, the process freezes, and all the lights on the ACS panel start blinking. It says not to touch the stick, but it seems like it's "touching" itself because of the force feedback. I tried increasing the dead zones, as a friend in a related thread suggested, but the process freezes even earlier, and almost immediately all the lights start blinking. If anyone has the same joystick, please tell me how you resolved this. Tech support suggests disabling FFB, but that's unacceptable

Edited Sunday at 04:46 AM by VANOIS
typos:(

[Psifire]

I'm having the same issue with my Sidewinder FFB2.  If I figure it out I'll post it here.

[VANOIS]

I have attached the track, I hope it will help fix the problem sooner

Островная разборка-20250920-132221.zip

[Psifire]

If you get a chance, try this process and see if it works.

After Aekran Test, Engine Start, and Fast Alignment, and with the Ground Power disconnected:

Clear controller mappings for Pitch and Roll from all controllers.

Flip the AFCS switch and allow the BIT to complete (Takes about a minute.  Stops a couple of times during the test)  Wait until Damper Off warning shuts off.

Remap the Pitch and Roll Axis.

This isn't a permanent solution, but it's the best I have so far.

Edited yesterday at 01:10 PM by Psifire