FA18 Stby Gauges dcs bios help

[danos_2503]

Getting stuck with finding a arduino sketch to work with the stby gauges as in Knots, velocity, altimeter plus the rad altimeter gauge. Currently using x27.168 stepper motors i have easy drivers, but i do see you can connect directly to arduino so happy to go either way. i pretty much have my whole cockpit working, but getting stumped on these. if you want to see my cockpit you can check out my instgram page fa18hornetpit some photos below so you see that i do have some idea at least on design and building had no issue with dcs bios as in switches, led's,rotary encoders push buttons etc.. and while i am asking any help on the oled sketches to for the alimeter would be great. 

[MAXsenna]

How much time did you spend on that? Looks awesome!

Sent from my SM-A536B using Tapatalk

[danos_2503]

@MAXsenna thanks! coming up two years now the canopy even works runs on compressed air. Still a bit to do i have slowed down a bit as i can use it as is so just fine tuning and getting things working that havent been like these standby gauges.

[MAXsenna]

11 minutes ago, danos_2503 said:

the canopy even works runs on compressed air

Careful now, so you don't accidentally make yourself a working ejection seat!  

[No1sonuk]

You might find what you need at Open Hornet ( https://openhornet.com/ )
BUT, some of what they've done there is unnecessary over-engineering.

[Rapti]

Most people used a monitor for this instrument cluster including me.

Edited 2 hours ago by Rapti