cannot produce and mssing track file No Datalink? Mission Setup Help

[RubberDogSh1tOutOfHKG]

I made a CAP Mission, and unlike the few other A-G Missions I've made the last few days I do not get any data from AWACS or Wingman.

AWACS is not more than 200NM from Bandits, and AWACS will give me Bogey Dope and Picture via Voice. On correct Frequency.
I do not get any HSD Position Report from my Wingman. But can still hear him on voice.

I start up the bird the same way as before.

Any suggestions on what might be the issue?

[RubberDogSh1tOutOfHKG]

Air Start works, so something during my Start Up Procedure. Hmmmm

[RogueSpecterGaming]

2 hours ago, RubberDogSh1tOutOfHKG said:

Air Start works, so something during my Start Up Procedure. Hmmmm

Make sure you go to the DLNK page on the DED and verify it says FINE and not COARSE. If it does turn it off then back on by pressing MSEL on the first setting.

Also, if there is terrain between the bandits and the AWACS (due to them flying low) they probably won't show up.

Also, if you can post a track so we can see exactly what is happenining that would be great.

[RubberDogSh1tOutOfHKG]

I think I found the solution.
GPS signal was too weak to penetrate the Hangar, if I waited outside until I got the signal before switching the MIDS on it worked!
First time to have experienced that

[MAXsenna]

1 hour ago, RubberDogSh1tOutOfHKG said:

I think I found the solution.
GPS signal was too weak to penetrate the Hangar, if I waited outside until I got the signal before switching the MIDS on it worked!
First time to have experienced that

Yeah, this can happen too if you're under a roof. 

[RogueSpecterGaming]

1 hour ago, RubberDogSh1tOutOfHKG said:

I think I found the solution.
GPS signal was too weak to penetrate the Hangar, if I waited outside until I got the signal before switching the MIDS on it worked!
First time to have experienced that

Yes, that is modelled. Under any type of hardened shelter will prevent GPS signal from being captured. Best practice is to taxi out and wait. Easy way to know if you have GPS signal is to go to the TIME (6) page and you should see GPS on the top line next to SYSTEM. If you dont see GPS then you dont have the signal captured from the satellite.

[RubberDogSh1tOutOfHKG]

Yeah, that is how I figured it out (After having checked the Manual)