Problem editor mission

[Predator-78]

Hello, I have a problem in achieving missions with the editor.

1) I entered the land units and assigned them a waypoint but the units remain firm when you start the mission.

2) To display a warning a pilot of the Ka-50 while in flight, for example, if access to an area where there are dangerous enemy units, what parameters should I set?

Once I set-Unit inside zone-messages;

or:

Once inside moving parts-Unit - messages;

 

Unfortunately not display anything on a mission, you can help me thanks.

[Warbird_242]

Not sure about the units never had such a problem myself.

 

To display a message, you need to set trigger zones.

 

Unit inside zone will trigger when a unit enters a trigger zone, and unit inside moving zone means you can 'tie' the zone to a unit - for example you could have two planes - when they get within 20km you could activate a message. With the message, make sure you set how long you want the message to remain.

 

Hope that helps

 

Warbird

[Predator-78]

Not sure about the units never had such a problem myself.

 

To display a message, you need to set trigger zones.

 

Unit inside zone will trigger when a unit enters a trigger zone, and unit inside moving zone means you can 'tie' the zone to a unit - for example you could have two planes - when they get within 20km you could activate a message. With the message, make sure you set how long you want the message to remain.

 

Hope that helps

 

Warbird

 

Yes, I understood the procedure to be performed.

My problem is that after you put the trigger zone, and set the parameters for displaying messages, they do not appear.

When I enter the helicopter within the trigger zone, the message does not appear.

The procedure is as follows:

ONCE - INSIDE-UNIT ZONE-MESSAGES

 

also by entering:

ONCE-UNIT MOVING INSIDE ZONE-MESSAGES

 

the message does not appear.

[Warbird_242]

sorry as I said above - no idea.

 

Anyone else have any ideas?