CAS JTAC mission

[gekoiq]

Decided to throw my mission up on here. I can't get it to play all the way through. It will randomly lock up on me after contacting the JTAC. If anyone can offer advice as to why it locks up I'd be much obliged. Rather standard On-Call CAS type mission. In theory you will get tasked with 3 targets. A T72 (and possibley a BMP2 if the LAV's dont kill it), another T72, and a building with troops in it.

 

It uses transparent JTAC switching to give the illusion of 1 jtac that gives multiple targets. You will have to check-in again after each group is destroyed (sometimes only 1 vehicle). Just follow the simple instructions in the messages you get as you follow the waypoints.

 

Watch the city as you approach after getting the "need CAS message" there is quite the firefight going on down there, lots of fireworks. I've decided making intense ground battles is very fun.

 

Also feel free to change it to "ramp start"... though getting it all fired up and into the target area just to have it lock up on you is rather infuriating.

 

Enjoy.

Mission1.miz

[MadTommy]

I had a quick look at your mission...noticed a couple of things.. one that might be your issue.

 

In your JTAC target details under 'weapon' you have 'missiles', do you have missiles or ATGM? You might be forcing a command that is not possible, hence locking up. I'd change that, try Auto.. see if that works 1st.

 

Also i'd make the JTAC 'invisible' over 'immortal'.. that way he wont influence the AI.

 

And lastly.. only your 1st JTAC is actually a JTAC.. the others have no commands, call signs etc setup.

 

Hope that helps.

Edited November 12, 2010 by MadTommy