Tm Warthog controls messed up

[Engage]

very new to all this guys so go easy on me

got my new warthog yestaday, installed all the software, drivers

but i had target open when i started dcs 10c the game, and now most of the switches on the stick and throttle dont work how can i get them back to default, of how they should be, if i hadnt of started up Target.:music_whistling:

kind regards

josh

 

or has anyone got a profile i can use?

[hassata]

I think you can go to DCS OPtions right click anywhere in the WH throttle column and load the WH defaults, then do the same for the joystick.

[Flamin_Squirrel]

Run DCS A-10 WITHOUT TARGET running. Should be fine.

[Engage]

I think you can go to DCS OPtions right click anywhere in the WH throttle column and load the WH defaults, then do the same for the joystick.

you cant right click, but i did clear categories, thinking i could then load defaults, but it wont let you do them all at once.

i have to load each button slider, on there own, and to be honest i havnt got a clue as to what should be what:(

regards

josh

[Geskes]

select load profile, browse to config/input/aircrafts/a10c/ select .lua corresponding with controller. Done.

[Engage]

select load profile, browse to config/input/aircrafts/a10c/ select .lua corresponding with controller. Done.

Thanks for the help but i installed the game again, that sorted it out:thumbup:

regards

josh

[Teej]

Having TARGET open will do absolutely nothing to DCS. I've done it many times.

 

Running a profile may make your stuff not work right while the profile is running....but as soon as you 'stop' the profile, the stick should go back to working as default with A-10.

[Midwestboi]

I think one of the major problems is duplication. You can't have a profile AND DCS set for the same device action. So if you are using an external profile for certain buttons or actions- make sure they are not duplicated within DCS- this will avoid any conflict problems.

Edited December 26, 2010 by Midwestboi
correction