dbeaty Posted June 24, 2011 Posted June 24, 2011 Can someone steer me in the right direction with the new HARS EGI start-up procedure. I can never get the...I think it's called the ...EAC switch to arm during start up. I get everything on and switch to EGI, but the EAC arm switch on the autopilot panel will not work. But then usually if I take off and fly for about 5 minutes or so, it then allows me to arm it and the EAC caution light goes out. What am I doin' wrong here? Thanks! Asus P6 MB i7 6GB OC'd 3.8Ghz Win 7 64bit Cogage Cooler Radeon 6870 OC'd 975Mhz Core 1250 MHz RAM TM Afterburner TrackIR [sIGPIC][/sIGPIC] Aardvarking it
Iceman2011 Posted June 24, 2011 Posted June 24, 2011 Have you done complete alignment, where the CDU says 4.0.0.8 and then pressed "NAV"?
WarriorX Posted June 24, 2011 Posted June 24, 2011 Here ya go dbeaty. http://forums.eagle.ru/showthread.php?t=74738&highlight=startup+procedure [sIGPIC][/sIGPIC] "Is that you John Wayne?.......Is this me?" Full Metal Jacket //My Mission Data Card//My Cold Start Checklist //Clearing a Hung Store Tutorial //CDU Offset//Asterisk Error Correction Procedure//JTAC UTM Coordinate Entry Tutorial//JTAC 9 Line Lat Long Coordinate Entry Tutorial
dbeaty Posted June 24, 2011 Author Posted June 24, 2011 Have you done complete alignment, where the CDU says 4.0.0.8 and then pressed "NAV"? Need to run through the new training session I guess. It's fixed now I think... I thought I did set NAV mode in the CDU, after the "Load All" and test bit and setting "Take off Trim." with. Whenever I have the problem, everything is working - NAV data in the TAD ect...I'll make sure I check that line item again and see if that's my prob. But if I take off, the EAC arms 5-10 minutes into the flight just fine, so maybe it is an alignment problem I'm having. Asus P6 MB i7 6GB OC'd 3.8Ghz Win 7 64bit Cogage Cooler Radeon 6870 OC'd 975Mhz Core 1250 MHz RAM TM Afterburner TrackIR [sIGPIC][/sIGPIC] Aardvarking it
Recommended Posts