moving the eye view back towards the seat

[Ed Hunter]

Hi All

I have just upgraded to DCS world and installed combined arms and the blackshark1 and the blackshark2 upgrade.

 

The pilots head view for me now is very close to the instrument panel (as was the A-10c)

 

searching the posts found how to move the view back in the A-10 in the snapviewdefault.lua by editing line " Snap[11][13]["x_trans"] = 0.30"] = 0.30",

 

But the lua for black shark only goes to line " Snap[9][13]["z_trans"] = 0"

 

According to the read me the Snap[11][13] is for in cockpit view?

 

So how do i edit so my head is not right on top of the panel?

 

Just to add also im using 3 screens in this view the image is from the top of shval monitor to approximately 3/4 of the way up the heads up display

 

If i go to a single display screen the image shown is from the bottom of the shval to above the top of the heads up display

 

 

Thanks in Advance

[RedRain]

Hey Ed

C:prog files/Eagle Dynamics/DCS World/Config/View/View lua/Line 136 (Ka50) :- Change 120 to what ever suits you best. I run at 6048 x 1080, 145 suits me best.

 

Good Luck.

[Ed Hunter]

Fantastic RedRain

works a treat just need to tweak it a bit for my screens 6100 x 1080

 

thank you

[RedRain]

Glad I could help

[Ed Hunter]

Help again please ?

 

just reinstalled the dcs world and the modules i have back in

 

and then went to edit the view.lua to reset my head view point and the lua now only has 128 lines not the 128 my old one had.

 

where do i now edit to move eye-point back again

or can i just copy/paste old lua into the view folder ?

 

thanks